Abstract
An all composite bridge with integral sensor network has been designed and built at the University of Missouri-Rolla (UMR). An extensive experimental study and finite element analysis were carried out to obtain and compare properties (stiffness, strength, failure modes) of 76 mm (3 in) square hollow pultruded Fiber Reinforced Polymer (FRP) tubes and their assemblies. Tube assemblies were used in the fabrication of bridge deck designed for H-20 truckloads as specified by the American Association of State Highway and Transportation Officials (AASHTO). The bridge is 9.14 m (30 ft) long and is 2.74 m (9 ft) wide. All the coupons were tested under three- or four-point bending. Experimental results show excellent linear elastic behavior up to failure and are in good agreement with finite element solutions. A quarter portion of the full-sized bridge deck was then tested for its structural performance under design and fatigue loading and also for ultimate load capacity to evaluate the bridge response. The characteristics of the full-size bridge deck were determined by analyzing the performed tests. The test sample showed almost no reduction in stiffness or strength after 2 million cycles of fatigue loading in excess of the design load. The bridge was installed at the UMR campus in July 2000. The bridge is equipped with fiber optic sensors, and the response of the bridge will be remotely monitored.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
