Abstract
Conventional wireless sensors rely on chemical batteries. Replacing or charging their batteries is tedious and costly in some situations. As usable kinetic energy exists in the environment, harvesting vibration energy and converting it into electrical energy has become a hotspot. However, the power output capability of a conventional piezoelectric energy harvester (PEH) is limited by its low operational frequency. This paper presents a new mechanism for achieving continuous triple-frequency-up voltage output in a PEH. The proposed system consists of a slender piezoelectric cantilever with two short cantilever-based stoppers. The piezoelectric cantilever undergoes a pure bending mode without contacting the stoppers. In addition, the beam switches into a new vibration mode by contacting the stoppers. The vibration modes switching yields reverses the signs of voltage outputs, inducing triple-frequency-up voltage output. Analytical and experimental investigations are presented, and it is shown that a significant triple-frequency up-conversion of the voltage output can be obtained over a wide frequency range. A peak power output of 3.03 mW was obtained. The proposed energy harvester can support a wireless sensor node.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
