Abstract
This work shows a procedure for modeling and control of level and flow processes. It uses the EMSO simulator to connect to a process by means of a SIMATIC S7-200 PLC as interface for the communication between the process instrumentation and the controller computing system. In order to supervise the variables, a SIMULINK model was connected to a laboratory process module through OPC communication. The model obtained was used in the design of controllers PID and PBSM, which were tested for step disturbances of the set point and an imposed set point trajectory.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Revista Facultad de Ingeniería Universidad de Antioquia
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
