Abstract
Acceleration monitoring is an important technical means of seismic monitoring, oil exploration, deep well observation, etc. A miniaturized fiber Bragg grating (FBG) acceleration sensor with three cantilever beams is proposed against the fact that it is difficult for fiber-optic sensors to meet the requirements for low-frequency vibration monitoring. First, the model of the FBG acceleration sensor was built and theoretically analyzed; second, the effect of structural parameters on sensor sensitivity and natural frequency was analyzed, and the sensors were subjected to static stress analysis and modal simulation analysis through the ANSYS finite element analysis software; finally, the real sensors were developed and subjected to performance tests with a low-frequency vibration test system. According to the result, the natural frequency of the sensor is about 64Hz, and its sensitivity is 201.3pm/g; favorable linearity is observed at the working frequency band of 0.1-40Hz, and the transverse interference is less than 2.51%. The research findings offer a reference for the development of like sensors and the further exploration of the lower limit of low frequency.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
