Abstract
Grapevine rhytidome (the outer layer of bark on trunk), as an abundant and low-cost precursor, was used to prepare granular activated carbon with high surface area for the removal of methyl violet from aqueous solution. Microwave heating source was used to reduce the treatment time and energy consumption. To optimize the preparation, the effects of the different parameters, such as phosphoric acid concentration, acid/precursor weight ratio, impregnation time, microwave power, radiation time, and oven heating time on the ability of the samples for removal of methyl violet were studied. The obtained activated carbon was characterized by N 2 adsorption/desorption, SAXS, TEM and SEM methods. The adsorption of methyl violet onto the activated carbon was studied from both equilibrium and kinetic point of view and the results were compared with the commercial granular activated carbon. The rate of adsorption onto the prepared activated carbon was faster than commercial activated carbon. Different kinetic models were used to analyze the experimental kinetic data. The obtained activated carbon showed higher adsorption capacity (more than twice) for the adsorption of methyl violet in comparison with the commercial one. The equilibrium data were analyzed using different isotherm models. Adsorption was found to be maximum in the pH range 7–9.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.