Microstructure, phase evolution and mechanical properties of nickel-silicon carbide reinforced Ti6Al4V alloy processed by pulsed electric current sintering

Abstract

In this work, fully densified Ni–SiC reinforced Ti6Al4V matrix composites were consolidated by pulsed electric current sintering (PECS) technique. The microstructural evolution and mechanical properties of the developed composites with varying SiC contents were investigated. The microstructural study revealed in-situ precipitation of TiC, Ti5Si3 and Ti3SiC2 strengthening phases within the composites. The α colony size in the composites was notably reduced compared to the fabricated SiC-deficient samples due to the addition of SiC additive into the Ti6Al4V alloy matrix. The in-situ precipitated phases enhanced the mechanical properties of the composites. Composite reinforced with 10 wt% SiC (TNi10SiC) displayed the highest hardness value of 609.8 ± 50.9 HV0.5 among the sintered samples, translating to an increment of about 88 % compared to the unreinforced sample T. Among the sintered samples, the highest flexural strength of 2094.32 ± 97.67 MPa was obtained for the TNi5SiC composite, after which the flexural strength deteriorates with increasing SiC content as witnessed in TNi10SiC composite with the least flexural strength of 863.67 ± 71.57 MPa due to agglomeration of the reinforcement phases within the composite. Samples reinforced with 0 wt% SiC experienced a ductile fracture, and the composites containing 2.5 wt% - 5 wt% SiC content witnessed intergranular and interlamellar fractures. However, at higher SiC content, reinforcement pull-out and debonding of the agglomerated reinforcement phases predominates, and composites fail by brittle fracture.