Abstract
Abstract The microstructure and phase composition of die cast and thixocast ZAEX10430 (Mg–10Zn–4Al–3Ce–0.3Ca) alloy were studied. Two intermetallic phases were identified in both the die cast and the thixocast specimens: the τ-phase doped with calcium (Mg,Ca)32(Al,Zn)49 (or τ′-phase) and the (Al,Zn)xCe isomorphous phase with Al2CeZn2 and Al4Ce. In all of the specimens, the τ′-phase crystallized mostly as fine elongated particles and within a lamellar constituent. Needle-like (Al,Zn)xCe phase particles were visible in the die cast specimens, whereas coarse particles of various cross-sectional shapes (polygonal, elliptical, rod-like, etc.) were observed in the thixocast specimens. The difference in morphology of the intermetallic (Al,Zn)xCe particles in the matrix and the presence of large primary α-Mg grains in the thixocast specimens was used to explain the different creep behavior of die cast and thixocast ZAEX10430 alloy reported previously.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.