Abstract
A defect study of ultra-fine grained (UFG) Cu prepared by high-pressure torsion (HPT) will be reported. Conventional positron annihilation spectroscopy (PAS) including positron lifetime (PLT) and Doppler broadening (DB) techniques was employed as the main experimental tool. PAS was combined with transmission electron microscopy, X-ray diffraction and Vickers microhardness (HV) measurements. First, lattice defects introduced by HPT were characterized. A very high concentration of defects created during HPT deformation was observed and the two kinds of defects could be identified: dislocations and small vacancy clusters (microvoids). Further investigations were focused on (i) the radial distributions of defects and (ii) the evolution of microstructure during HPT processing. The results of the present study are consistent with an increase of shear strain from the sample centre toward its periphery. Extended lateral mapping of microstructure was performed using HV and DB techniques. The latter one reveals a significant non-uniformity of defect distribution which was less pronounced in the HV measurements.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
