Microstructure and Deformation of Over-Aged Al-Zn-Mg-Cu Alloy with Fine Grains during Multiple Stress Relaxation Tests

Abstract

Strong obstacles can greatly impede the motion or transmission of dislocations, which can be reflected by strain rate sensitivity and activation volume. In this study, the strain rate sensitivity and activation volume of overaged Al-Zn-Mg-Cu alloys with a grain size of 3.1 μm fabricated by powder metallurgy were measured by two different methods: a stress relaxation test and strain rate jump test. It was found that the former method gave much higher strain rate sensitivity values. After reviewing the conventional theory of stress relaxation test, it is unreasonable that the activation volume at each cycle during the stress relaxation test is a constant. At a strain rate higher than 10−5 s−1, ∂lnε˙/∂τ*, which is proportional to the activation volume in the conventional theory of the stress relaxation test, increases significantly, and nearly linearly increases with the strain rate in its logarithmic form, while at a strain rate lower than 10−5 s−1, the value of ∂lnε˙/∂τ* is nearly a constant. The grain boundary sliding mechanism was incorporated into the plastic deformation during the stress relaxation test, and the strain rate sensitivity and activation volume obtained by stress relaxation after modification agree well with that obtained by the strain rate jump test.