Abstract
The microstructure of CoCr films varies with the fabrication conditions. The surface structure deteriorates faster when Cr density is low. When the grain structure is very fine, the deterioration is faster when the grain interfaces are very clearly-defined. No significant difference was found in Ms decrease when an SiO <inf xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</inf> protective film was deposited on the CrCo. The thickness was varied to 100 Å, 300 Å or 500 Å. A protective film thickness of at most 100 Å proved to be effective in producing good corrosion resistance.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
