Microstructural study of deformation zones during cone penetration in silt at variable penetration rates

Abstract

During conventional cone penetration testing in silt, the soil will normally be partially drained. If the penetration rate varies, time for drainage is altered and therefore the measured cone resistance and pore pressure will change. This paper studies the change in soil microstructure around the probe during cone penetration carried out at different penetration rates to investigate the failure mechanism and the processes controlling drainage in silt. Backscattered electron images of polished thin sections prepared from frozen samples at the end of penetration were used. Making use of advanced image-processing techniques, the statistical distribution of particle orientations and the local porosity were investigated for zones around the cone tip and shaft. The spatial distribution of the measured microscale parameters in the region near the probe indicates that the soil deformation during a piezometric cone penetration test (CPTU) in silt leads to the formation of both contractive and dilative zones. The macro response of the material, presented by the pore pressure and cone penetration resistance measured during the test, results from the competition between these zones during penetration, which is shown to be dependent on the penetration rate.