Microstructural assessment of laser nitrided Ti-6Al-4V alloy

Abstract

A microstructural study of the phases developed during the laser nitriding of a Ti-6Al-4V alloy by, using a CL5 continuous CO2 laser with a spinning beam and concentration of 80% nitrogen, was undertaken. The vertical sections, perpendicular to the melt track were examined by optical microscopy and scanning electron microscopy (SEM), while specimens for X-ray diffractometry (XRD), X-ray photospectroscopy (XPS) and transmission electron microscopy/selected area electron diffraction (TEM/SAED), were taken parallel to the melt track. In this way the variation in microstructure as a function of depth from the laser treated surface, was studied. This supplemented XRD and XPS investigations undertaken previously. Two zones were identified. Zone 1, within 50 μm of the surface, contained well defined dendrites of fcc TiN0.8, plus hcp TiN0.3 and hcp α′Ti. Zone 2, below 50 μm, consisted of needles of hcp α′Ti. From a consideration of the hardness profiles in Zone 2, it is suggested that at the top of the zone, the α′ phase is, in fact, a solid solution containing 3–4% N, which decreased to <1% N at the bottom of the zone. The TEM/SAED study permitted the three phases fcc TiN0.8, hcp TiN0.3 and hcp α′Ti to be identified through a combination of morphology and SAED patterns. This also showed that the fccTiN0.8 contained fringes, which were considered to be stacking fault fringes and allowed this phase to be readily recognized in the TEM. The presence of stacking faults may be associated with the high nitrogen concentration of 80% used for the laser nitriding in this work.