Abstract
With the miniaturization of quantum sensors, the fabrication of alkali metal vapor cells based on micro-electromechanical systems (MEMS) has become increasingly important. However, the fabrication of MEMS vapor cells remains a challenge. In this study, a microfabricated millimeter-level vapor cell was fabricated and tested. The silicon cavity was fabricated by dry etching and chemical polishing. After injection of alkali metal and buffer gas, a two-step low-temperature anodic bonding was employed. The first step was non-isothermal to keep the alkali metal in the low-temperature pole plate and the second step was isothermal to improve the bonding strength, enhancing the hermeticity. Then, the vapor cell was tested for sidewall roughness, bonding strength, and leakage rate. Subsequently, Rb D1 line absorption spectroscopy, stability, and the single-beam magnetometer signal were tested. The results show the fabricated vapor cell had high stability, providing a basis for the miniaturization of quantum devices.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
