Abstract
The interest in the application of carbon nanotube (CNT) composites is recently increasing in several industrial sectors. The main reason for this growing attention is the reinforcing effect of the CNTs. However, the composite use is limited by technological issues concerning the manufacturing processes when small features are required. A multistage process chain could exploit the advantages of suitable processes to enhance the control of the filler orientation. This paper investigates the feasibility of milling micro features on micro injected specimens of POM/CNT and LCP/CNT composites. Design of experiment is used to study a suitable experimental design to investigate the influence of the material and the process parameters on the machinability and the feature geometry. POM-based composites showed a better machinability and allowed a fabrication of more accurate features, while LCP showed high cutting forces and the presence of diffused burrs, preventing the fabrication of very small features.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Machining and Machinability of Materials
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
