Abstract
Micro deep drawing was prompted by the rapid development of micro electro mechanical systems, electron industries, new energy, and biomedical in recent years because of its mass production, high efficiency, high precision, low cost and no pollution. However, most researches concentrated on micro cylindrical cups, few studies were reported on other shaped parts. Micro deep drawing of micro conical-cylindrical cups was investigated in this study by using a micro blanking-deep drawing multiple operation mould. The specimen material was pure copper C1100 with a thickness of 50μm which was thermally treated in vacuum condition at 723K for 1h. Micro deep drawing experiments were carried out at room temperature on a universal testing machine at a drawing velocity of 0.05mm/s with the lubrication of polyethylene (PE) film. The results showed that micro conical-cylindrical cups with internal conical bottom diameter of only 0.4mm were well formed. The drawing force and limiting drawing ratio (LDR) micro conical-cylindrical cups were also discussed at the end of this paper.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
