Melt fracture, melt viscosities, and die swell of polypropylene resin in capillary flow

Abstract

AbstractThe melt fracture, shear viscosity, extensional viscosity, and die swell of a polypropylene resin were studied using a capillary rheometer and dies with a 0.05‐cm diameter and length/radius ratios of 10, 40, and 60. A temperature of 190°C and shear rates between 1 and 5000 s−1 were used. A modified Bagley plot was used with consideration of pressure effects on both the melt viscosity and end effect. The shear viscosity was calculated from the true wall shear stress. When the true wall shear stress increased, the end effect increased and showed critical stresses at around 0.1 and 0.17 MPa. The extensional viscosity was calculated from the end effect and it showed a decreasing trend when the strain rate increased. Both the shear and extensional viscosities correlated well with another polypropylene reported previously. The die swell was higher for shorter dies and increased when shear stress increased. When the shear rates increased, the extrudate changed from smooth to gross melt fracture with regular patterns (spurt) and then turned into an irregular shape. In the regular stage the wavelength of the extrudates increased when the shear rate increased. The frequency of melt fracture was almost independent of the shear rate, but it decreased slightly when the die length increased. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 87: 1587–1594, 2003