Abstract
An in-line mass spectrometer and Langmuir probes have been employed to examine mechanisms of plasma immersion hydrogen passivation of grain boundary defects in polycrystalline silicon thin film transistors. Relative fluxes of H+ and H+2 as well as total ion current density were measured at the substrate location in an electron cyclotron resonance hydrogen discharge. Measurements were made over a range of operating conditions over which passivation rates have been shown to vary dramatically. Data presented show a strong correlation of both H+ flux and ion bombardment energy with good transistor performance obtained at operating pressures below 1 mTorr. This suggests that discharge operating conditions that promote dissociation of H2 to form H and H+ (which may diffuse more rapidly through solid material than H2), as well as increased sheath voltages and therefore ion energy at the substrate, are important to obtaining acceptable process rates.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.