Mechanical Properties and Morphology of LDPE/PP Blends

Abstract

Two types of polypropylene (PP) with different molecular structure, namely, homogeneous PP (PPH) and PP block‐copolymer (PPC), were blended with a long chain, branched, low density polyethylene (LDPE) in a twin screw extruder and then injection moulded into test specimens; the mechanical properties and morphology of the blends are reported. The tensile strength, elastic modulus, flexural strength, and flexural modulus of the blends increased monotonically with increasing PP content, although exhibiting a slightly negative deviation from the rules of mixtures due to the relatively poor compatibility of the components, which caused the blends to separate into individual phases. Comparatively, these mechanical properties of the LDPE/PPH blend were much higher than that of the LDPE/PPC blend, which was attributable mainly to the fact that the mechanical properties of neat PPH are stronger than that of neat PPC. With respect to the impact strength of the blends, a maximum value appeared in LDPE/PPH blends when PPH content was about 20% and also in LDPE/PPC blends when PPC content was about 40%.