Abstract
Fe 65.5Cr 4Mo 4Ga 4P 12C 5B 5.5 bulk amorphous rectangular bars with a cross-section of 2×2 mm 2 and a length of 30 mm were produced by copper mold casting. The as-cast bars as well as annealed samples were investigated by compression and Vickers hardness tests. The fracture strength for the as-cast samples σ f is 2.8 GPa and the fracture strain ε f is 1.9%. Upon annealing at 715 K for 10 min, i.e. at a temperature below the calorimetric glass transition, the fracture strain drops to 1.6% and no plastic deformation is observed. The Vickers hardness HV for the as-cast samples is about 885, and increases to 902 upon annealing. The fracture behavior of this Fe-based bulk glassy alloy is significantly different in comparison with the well-studied Zr-, Cu- or Ti-based good glass-formers. The fracture is not propagating along a well-defined direction and the fractured surface looks irregular. Instead of veins, the glassy alloy develops a high number of microcracks.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have