Mechanical and Processing Properties of Plasticised PVC/Wood Composites.

Abstract

The paper presents the results of testing the properties of wood-polymer composites (WPC) based on plasticised poly(vinyl chloride) (PVC-P). Materials with variable contents of wood filler (Arbocel C 320) or plasticiser (di-isononyl phthalate) were produced and then analysed. The share of wood flour in the material was up to 50 phr, and the plasticiser content was up to 40 phr. Functional properties, such as tensile properties, mechanical properties at variable temperature (DMTA), and water absorption, as well as processing properties such as rheological properties and analysis of the fusion process, were analysed. The influences of wood flour and plasticiser on the composites' properties in the solid and melted state were found. For example, with 40 phr of plasticiser, increasing the filler share from 0 phr to 50 phr resulted in an increased tensile modulus from 18 MPa to 274 MPa and viscosity at a share rate of 20 s-1, from 721 Pa·s to 1581 Pa·s. However, increasing the share of plasticiser from 20 phr to 40 phr with 30 phr of filler reduces the value of these properties from 1760 MPa to 112 MPa and from 2768 Pa·s to 1151 Pa·s, respectively. It was also found that increasing the share of wood flour in the composite noticeably reduces the effectiveness of the plasticiser.