Influence of organically modified nanoclay and TiO2 nanopowder on the properties of Azadirachta indica wood flour-reinforced high-density polyethylene, low-density polyethylene, polypropylene, and polyvinyl chloride nanocomposite

Abstract

The nanocomposites of high-density polyethylene, low-density polyethylene, polypropylene, and poly(vinyl chloride) reinforced with Azadirachta indica wood flour (WF) and different amounts of the organomodified nanoclay and titanium dioxide (TiO2) nanopowder were produced by melt-blending process followed by compression molding. Polyethylene- co-glycidyl methacrylate (PE- co-GMA) was used as a compatibilizer. TiO2 nanopowder was synthesized by sol–gel method and characterized using transmission electron microscopy (TEM). The average size of the synthesized nano-TiO2 was 17.5 nm, which was confirmed both by TEM and X-ray diffraction (XRD) study. The distribution of nanoparticles in the nanocomposites was also examined by the XRD study. The surface modification of the TiO2 nanoparticles by organic surfactant cetyl trimethyl ammonium bromide and their interaction with the wood and the polymer were studied by Fourier transform infrared spectroscopy. Incorporation of compatibilizer PE- co-GMA, nanoclay, and nano-TiO2 significantly influenced the mechanical and thermal properties of the WF-reinforced composites. Wood polymer composites (WPC) reinforced with nanoclay and nano-TiO2 showed improved tensile strength, tensile modulus, flexural strength, flexural modulus, and hardness. Maximum improvement in mechanical properties was shown by WPC loaded with 40 phr WF, 2 phr nanoclay, and 2 phr of nano-TiO2. On inclusion of organically modified nanoclay and nano-TiO2, the WPC samples showed lower water uptake and higher chemical resistance. The nanocomposites were further examined by TEM study and thermogravimetric analyzer.