Mechanical and Microstructural Properties of Environmentally Friendly Concrete Partially Replacing Aggregates with Recycled Rubber and Recycled PET

Abstract

Today, waste generation is a worldwide problem, where the major source of waste is generated by worn-out tires and Polyethylene Terephthalate (PET) bottles. Therefore, as a way to provide an ecological disposal and reduce the environmental impact, the feasibility of producing ecological concrete (EC) with recycled rubber (RB) and PET as substitutes for natural aggregates is explored, determining their physical, mechanical and microstructural properties. This experimental study considered the replacement of fine aggregate with RB at 1%, 4%, 7%, 10%, 20% and 30%, and the optimum content of coarse aggregate plus the replacement of coarse aggregate with PET at 1%, 5%, 10% and 15%. The results showed that the optimum percentage of RB was 1%, which, when combined with PET, resulted that the design with 1% RB+ 1% PET was the optimum replacement combination, increasing 10% in bending, 1% in compression and for tension it decreased by 11%, in turn with the XRD test quartz and different aluminosilicates were found, such as portlandite and by SEM-EDS it was possible to visualize polymer flakes embedded in the analyzed fragment. It is concluded that RB and PET can be viable for the production of EC only if low percentages of replacement by natural aggregates are used.