Abstract
In this paper, we will describe an apparatus for measuring the through-plane electrical conductivity and also discuss its calibration. This paper describes operating procedures that were used and their effects on conductivity measurements. The following factors were found to affect the measurements accuracy and reproducibility: (i) the method used to polish the copper electrodes, (ii) the nature of the disk used to ensure a good electrical contact between the electrodes and the sample and (iii) whether these disks were reused or not. A 2 μohm drift was observed in the resistance measurements on a 24-h period. Two calibration methods were studied. The first calibration method was developed to calibrate the conductivity apparatus using power resistors and we were able to determine that a systematic error of 60 μohm was present. A second calibration method was then used to measure the electrical conductivity of two Poco graphite samples. Using our apparatus, the electrical conductivity of AXF-5Q and DFP-2 Poco graphite samples were both (60–210 μohm cm) lower than their reported statistical value of 1470 and 1500 μohm cm, respectively.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
