Abstract
To determine the dispersion relation, guided waves are excited in specimens over a broad frequency range. The surface displacements are measured over time and space. The recorded data are analysed using a quasi-three-dimensional spectrum estimation algorithm. In the time domain a fast Fourier transform is used to extract the frequencies. To obtain the wave numbers, in space a two-dimensional matrix-pencil approach is applied to the data set. Using a suitable constitutive model (transversely isotropic or orthotropic) dispersion curves are calculated. Good agreement was found between the experimental and the numerically calculated dispersion relations after adjusting the material parameters. Since the dispersion relation of a structure depends on the mechanical material properties frequency-dependent material parameters can be extracted from the above-mentioned relation between frequency and wave number.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call