Abstract

Abstract In the copper ball bond process, aluminum squeezes out under the ball deformation process since it is softer than copper. The final thickness of the copper ball decides the overall strength of the bond and hence knowledge of its final thickness helps to optimize the ball bond force during the bonding process. An etching method is developed for the analysis of the squeezed aluminum beneath the copper wire ball bond. The aluminum remnant obtained from the etching method is compared with that from the conventional cross-section method. It was found that the results are comparable and the present developed etched method is simple and elegant.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.