Abstract
Abstract The paper presents the results of numerical studies based on a mathematical model determined by the stress-strain state examination method. Numerical computations for two steel grades, namely H40 and C45, were made at similar strain and process rate parameters. As a result of the studies, the distribution of elastic and plastic zones was obtained, while the tube hollow drawing force was verified experimentally. The distribution of longitudinal, radial and circumferential stresses and, after the drawing operation, the distribution of residual stresses in the tube cross-section were also obtained.
Published Version (
Free)
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
