Abstract
We discuss the future of resist materials for sub-20-nm lithography and believe that polymer-bound PAG-based resists will be used to 16-nm node. There has been enough progress in resolution and sensitivity to justify the use of these materials. Polymer-bound PAG resists have shown that the principal demerit of acid diffusion can be overcome through attachment of the PAG anion to the lithographic polymer. Since the introduction of this chemically amplified resist approach, we have seen steady improvement in resolution, sensitivity, and LWR. We have also seen improvement in OOB response, outgassing, and pattern collapse. There is no doubt that continuous improvement is still required for these resist systems. We believe that increasing the overall resist quantum yield for acid generation substantially improves the shot-noise problem thereby leading to faster high-resolution resist materials. Using a 0.30-NA extreme ultraviolet tool with dipole, we can achieve 22-nm hp resolution, with a 12-mJ dose and a 4.2-nm LWR.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
