Mass fractions, solubility, speciation and isotopic compositions of iron in coal and municipal waste fly ash.

Abstract

Deposition of anthropogenic aerosols may contribute significantly to dissolved Fe in the open ocean, affecting marine primary production and biogeochemical cycles; however, fractional solubility of Fe is not well understood for anthropogenic aerosols. This work investigated mass fractions, solubility, speciation and isotopic compositions of Fe in coal and municipal waste fly ash. Compared to desert dust (3.1 ± 1.1%), the average mass fraction of Fe was higher in coal fly ash (6.2 ± 2.7%) and lower in municipal waste fly ash (2.6 ± 0.4%), and the average Fe/Al ratios were rather similar for the three types of particles. Municipal waste fly ash showed highest Fe solubility (1.98 ± 0.43%) in acetate buffer (pH: 4.3), followed by desert dust (0.43 ± 0.30%) and coal fly ash (0.24 ± 0.28%), suggesting that not all the anthropogenic aerosols showed higher Fe solubility than desert dust. For the samples examined in our work, amorphous Fe appeared to be an important controlling factor for Fe solubility, which was not correlated with particle size or BET surface area. Compared to desert dust (-0.05‰ to 0.21‰), coal and municipal waste fly ash showed similar or even higher δ56Fe values for total Fe (range: 0.05‰ to 0.75‰), implying that the presence of coal or municipal waste fly ash may not be able to explain significantly smaller δ56Fe values reported for total Fe in ambient aerosols affected by anthropogenic sources.