Mass and Heat Transfer of Pressure Swing Adsorption Oxygen Production Process with Small Adsorbent Particles

Abstract

Rapid-cycle pressure swing adsorption (PSA) with small adsorbents particles is intended to improve mass transfer rate and productivity. However, the mass transfer mechanisms are changed with reduction of particle size during rapid-cycle adsorption process. A heat and mass transfer model of rapid-cycle PSA air separation process employing small LiLSX zeolite particles is developed and experimentally validated to numerically analyze the effects of mass transfer resistances on the characteristics of cyclic adsorption process. Multicomponent Langmuir model and linear driving force model are employed for characterizing the adsorption equilibrium and kinetic. The results of numerical analysis demonstrate that the dominant mass transfer resistance of small adsorbents particles is a combination of film resistance, axial dispersion effect and macropore diffusion resistance. The oxygen purity, recovery and productivity of the product are overestimated by ~2–4% when the effect of axial dispersion on mass transfer is ignored. As particle size decreases, the front of nitrogen-adsorbed concentration and gas temperature become sharp, which effectively improves the performance. However, the adverse effect of axial dispersion on the mass transfer becomes significant at very small particles conditions. It is nearly identical shapes of nitrogen concentration and gas temperature profiles after adsorption and desorption steps. The profiles are pushed forward near the production end with an increase in bed porosities. The optimal oxygen recovery and productivity are achieved with a particle diameter of 0.45 mm and bed porosity of 0.39 during the PSA process.