Abstract
In this paper, we have presented a methodology combining ground penetrating radar (GPR) and a low-cost GPS receiver for three-dimensional detection of tree roots. This research aims to provide an effective and affordable testing tool to assess the root system of a number of trees. For this purpose, a low-cost GPS receiver was used, which recorded the approximate position of each GPR track, collected with a 500 MHz RAMAC shielded antenna. A dedicated post-processing methodology based on the precise position of the satellite data, satellite clock offsets data, and a local reference Global Navigation Satellite System (GNSS) Earth Observation Network System (GEONET) Station close to the survey site was developed. Firstly, the positioning information of local GEONET stations was used to filter out the errors caused by satellite position error, satellite clock offset, and ionosphere. In addition, the advanced Kalman filter was designed to minimise receiver offset and the multipath error, in order to obtain a high precision position of each GPR track. Kirchhoff migration considering near-field effect was used to identify the three-dimensional distribution of the root. In a later stage, a novel processing scheme was used to detect and clearly map the coarse roots of the investigated tree. A successful case study is proposed, which supports the following premise: the current scheme is an affordable and accurate mapping method of the root system architecture.
Highlights
Environmental issues such as the conservation of natural heritage and ancient trees have become priority objectives of urgent protection [1,2]
The wireless communication between ground penetrating radar (GPR) and self-tracking total station (TTS) system was developed to avoid cable connection, the crosstalk effect and the time synchronization required between the GPR and the positioning system have a significant impact on the data quality of GPR
In the pre-processing stage, time correction and a signal noise filter were applied to increase the clutter rate of the entire data
Summary
Environmental issues such as the conservation of natural heritage and ancient trees have become priority objectives of urgent protection [1,2]. The wireless communication between GPR and self-tracking total station (TTS) system was developed to avoid cable connection, the crosstalk effect and the time synchronization required between the GPR and the positioning system have a significant impact on the data quality of GPR. Other instruments such as charge-coupled device (CCD) cameras, real-time kinematic GPS (RTK GPS) and gyroscope can be used for actual GPR measurements.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.