Magnetocaloric effect and multifunctional properties of Ni–Mn-based Heusler alloys

Abstract

The studies of magnetocaloric properties, phase transitions, and phenomena related to magnetic heterogeneity in the vicinity of the martensitic transition (MT) in Ni–Mn–In and Ni–Mn–Ga off-stoichiometric Heusler alloys are summarized. The crystal structure, magnetocaloric effect (MCE), and magnetotransport properties were studied for the following alloys: Ni50Mn50−xInx, Ni50−xCoxMn35In15, Ni50Mn35−xCoxIn15, Ni50Mn35In14Z (Z=Al, Ge), Ni50Mn35In15−xSix, Ni50−xCoxMn25+yGa25−y, and Ni50–xCoxMn32−yFeyGa18. It was found that the magnetic entropy change, ΔS, associated with the inverse MCE in the vicinity of the temperature of the magneto-structural transition, TM, persists in a range of (125-5)J/(kgK) for a magnetic field change ΔH=5T. The corresponding temperature varies with composition from 143 to 400K. The MT in Ni50Mn50−xInx (x=13.5) results in a transition between two paramagnetic states. Associated with the paramagnetic austenite-paramagnetic martensite transition ΔS=24J/(kgK) was detected for ΔH=5T at T=350K. The variation in composition of Ni2MnGa can drastically change the magnetic state of the martensitic phase below and in the vicinity of TM. The presence of the martensitic phase with magnetic moment much smaller than that in the austenitic phase above TM leads to the large inverse MCE in the Ni42Co8Mn32−yFeyGa18 system. The adiabatic change of temperature (ΔTad) in the vicinity of TC and TM of Ni50Mn35In15 and Ni50Mn35In14Z (Z=Al, Ge) was found to be ΔTad=−2K and 2K for ΔH=1.8T, respectively. It was observed that |ΔTad|≈1K for ΔH=1T for both types of transitions. The results on resistivity, magnetoresistance, Hall resistivity in some In-based alloys are discussed.