Luminescence properties of SrB6O10:Ce,Gd phosphor for applications in OSL dosimetry and lighting

Abstract

Strontium hexaborate (SrB6O10) doped with different metals and/or lanthanides has been studied widely as the thermoluminescence (TL) dosimeter. However, there is almost no dosimetry study concerning the utility of Optically Stimulated Luminescence (OSL) on SrB6O10. This preliminary study aims to examine the luminescence properties of SrB6O10 phosphor for their application in the areas of dosimetry and lighting technologies. Undoped and doped material to get an OSL dosimeter were synthesized by incorporating the dopants Ce3+, in the range of 0.1–0.7 % wt, and Gd3+, in the range of 0.1–1 % wt into the SrB6O10 structure using the solution combustion (SCS) method. The structural and morphological characterizations were performed using X-ray diffraction (XRD) and Scanning Electron Microscope (SEM) methods, respectively. Two TL peaks of SrB6O10:Ce0.1%,Gd0.5% occurred at 70 °C and 182 °C after 1 Gy exposure to beta rays with a heating rate of 2 °C/s. The step annealing measurements were carried out to determine the traps responsible for the OSL signal. Various properties of the luminophore including dose-response and reusability were investigated using blue light stimulation. The phosphor showed a little variation of response up to 20 cycles within 2 % deviation (STD) from the first OSL readout. The OSL output within the range of 2–20 Gy was determined as linear. Radioluminescence (RL) measurement was investigated by emission in the range λem = 200–1000 nm. The parent compound displayed UV emission subdivided into UVA (315–400 nm), and UVB (280–315 nm) emissions at room temperature. The Chromaticity Coordinates (CIE) of SrB6O10:Ce0.1%,Gd0.5% were calculated as x = 0.2165, y = 0.1767. These remarkable characteristics show that, if developed, SrB6O10 could be used as an OSL dosimeter.