Abstract
A design for a millimeter wave RF probe card that removes resonance is proposed. The designed probe card optimizes the position of the ground surface and the signal pogo pins to resolve the resonance and signal loss issues that occur when connecting a dielectric socket and a PCB. At millimeter wave frequencies, the height of the dielectric socket and pogo pin matches the length of half a wavelength, allowing the socket to act as a resonator. When the leakage signal from the PCB line is coupled to the 2.9 mm high socket with pogo pins, resonance at a frequency of 28 GHz is generated. The probe card uses the ground plane as a shielding structure to minimize this resonance and radiation loss. The importance of the signal pin location is verified via measurements in order to address the discontinuity caused by field polarity switching. A probe card fabricated using the proposed technique exhibits an insertion loss performance of −8 dB up to 50 GHz and eliminates resonance. A signal with an insertion loss of −3.1 dB can be transmitted to a system-on-chip in a practical chip test.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.