Low-Cost Solution for RFID Tags in Terms of Design and Manufacture

Abstract

Even invented and applied initially during the World War II, RFID (Radio Frequency IDentification) technologies [1] have attracted much attention recently. Precisely speaking, RFID technologies have been applied very widely in some proprietary or closed systems, for example, animal control [2], portal control (access badges), etc. in last decades. The main advantages of RFID application are, storing item data in an electronic way even for further update, data access by electromagnetic wave in a wireless manner, and allowing quick multiple accesses to RFID tags. Based on the diverse applications, different spectrum bands are allocated, for example, LF (125 134.2 kHz and 140 148.5 kHz) for animal control, HF (13.56MHz) for electronic ticket, and UHF (868 MHz-928 MHz) for logistics, etc. Most of the frequencies are located in the ISM (Industrial, Scientific and Medical) bands [1]. However, RFID was emphasized again mainly because of the need of supply chain [3]. By proposing a standard for the format of electronic data used for goods items, of which EPC (Electronic Product Code) [4] is an example, the products can be registered at once when they are shipped out from the factories in one country, and be released when they are checked out at the counter of a supermarket in the other country in the world. These products might have been transferred through Customs of many countries and carried by different traffic means. When being through these check points, the related data stored in the tags are updated. This is called “product tracking” and is to be carried out in an “Internet of Thing (IOT)” [5]. This Chapter is to have a review on the technology theme – how to provide low-cost RFID Tags, when RFID technology is to be applied into the logistics area where the RFID tags are supposed to be not re-usable and to be as “zero-cost” as possible. Generally speaking, there are three major parts composing a RFID Tag’s total cost, namely, antenna, chip and assembly for them. The cost of antenna, in addition to the design phase, is mainly dependent on the manufacturing process. Therefore, manufacturing process should be focused if antenna’s cost, then the tag, is concerned. This is the theme of this Chapter. Not like the other antenna applications, for example, wireless LAN or mobile phone, in which antennas need to be compliant to the end products’ appearance by following the market trend. In the tag antenna industry, on the contrary, it does not need to design or modify the tag antenna often. The tag antenna just needs to electrically match the chip used in the beginning of design. It is not necessary for tag providers to prepare a wide product spectrum in the market. Again, not like the mobile phone industry, RFID tag’s players just