Low threading dislocation Ge on Si by combining deposition and etching

Abstract

Blanket and selective Ge growth on Si is investigated using reduced pressure chemical vapor deposition. To reduce the threading dislocation density (TDD) at low thickness, Ge deposition with cyclic annealing followed by HCl etching is performed. In the case of blanket Ge deposition, a TDD of 1.3×106cm−2 is obtained, when the Ge layer is etched back from 4.5μm thickness to 1.8μm. The TDD is not increased relative to the situation before etching. The root mean square of roughness of the 1.8μm thick Ge is about 0.46nm, which is of the same level as before HCl etching. Further etching shows increased surface roughness caused by non-uniform strain distribution near the interface due to misfit dislocations and threading dislocations. The TDD also becomes higher because the etchfront of Ge reaches areas with high dislocation density near the interface. In the case of selective Ge growth, a slightly lower TDD is observed in smaller windows caused by a weak pattern size dependence on Ge thickness. A significant decrease of TDD of selectively grown Ge is also observed by increasing the Ge thickness. An about 10 times lower TDD at the same Ge thickness is demonstrated by applying a combination of deposition and etching processes during selective Ge growth.