Abstract
Abstract Diffusion bonding of Ti-6Al-4V (TC4) to oxygen free copper (OFC) at low temperature was carried out using silver foil as interlayer. Results show that the interlay can prevent the formation of brittle Ti-Cu compounds and improve the interfacial microstructure and bonding strength of the TC4/OFC joint. Moreover, adding the silver interlayer greatly lowers the bonding temperature. The composition of the joint from the TC4 side to the OFC side is TC4 substrate, AgTi compound, Ag interlayer, Ag-Cu solid solution and OFC substrate. The tensile strength of the joint bonded at 700 °C for 1 h under 10 MPa bonding pressure has an excellent value of 150 MPa, higher than those previously reported in literatures. Fracture failure takes place in the Ag/OFC interface and ductile fracture can be observed on the fracture surface. It is suggested that the ductile properties of the AgTi compounds are superior to that of Ag-Cu solid solution in this joint.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
