Loss determination at a linear cascade under consideration of thermal effects

Abstract

Listen

Translate article

ABSTRACTTargeting higher efficiencies and lower fuel consumption of turbomachines, heat transfer and profile loss are research topics of particular interest. In contrast to that, the interaction of both was, so far, rarely investigated, but gains in importance in recent research activities. The profile loss of engine components can be characterised by the airfoil wakes at the blade rows utilising established measurement and evaluation methods for which an adiabatic flow is typically supposed. To enable the investigation of the influence of heat transfer at the blade on the loss characteristics, a novel evaluation procedure was set up. In addition to the pneumatic data, the total temperature in the airfoil wake at a linear cascade was measured by means of a five-hole probe with an integrated thermocouple. For the evaluation and analysis of these data, different definitions of the loss coefficient were investigated and, finally, extended to account for thermal aspects. Furthermore, established techniques to average the local wake data were applied and compared with special focus to their suitability for non-adiabatic cases. Moreover, an extended version of the mixed-out average as defined by Amecke was utilised applying not only a far-reaching consideration of a temperature gradient but also the inclusion of the third spatial dimension to enable the evaluation of field traverses in addition to single wake traverses. These techniques were applied to wake measurement data from a linear compressor cascade gained in a special test set-up in the high-speed cascade wind tunnel for different operating points and different blade temperatures. The suitability of the new methods could be proven, and initial steps of the aerodynamic analysis of the resulting data are presented. Thereby, the acquired techniques turned out as powerful methods for the evaluation of wake traverses on compressor and turbine cascades under non-adiabatic conditions.