Long-acting electrochemical lithium-recovery from original brine using super-stable spinel lithium manganate oxide

Abstract

with the unprecedented demand for raw lithium, the spinel LiMn2O4 has been widely studied for electrochemical Li-recovery from salt-lake brines, but its industrialization is hindered by the poor cyclability induced by manganese dissolution and Jahn-Teller distortion within octahedral structure. In this work, Cr-doped and carbon-coated LiMn2O4 (C-LMO-Cr) electrodes prepared via coprecipitation-calcination method are employed to improve cycling stability and lithium selectivity for electrochemical Li-recovery. The results confirm the C-LMO-Cr electrode exhibits super-high retention rate of 98.76 % and 95.70 % of the initial capacity (27 mg·g−1) after 300 and 500 cycles, respectively. The carbon buffering on the C-LMO-Cr surface effectively impedes the initial manganese dissolution with the enhanced charge transfer. Moreover, the structural evolution from Raman/XPS analysis and theoretical calculations confirms that the shrinking lattice of the carbon-buffering LMO-Cr enhances Li+ selectivity and Li+ migration. When assembled in a hybrid capacitive deionization (HCDI) device, the optimal C-LMO-Cr electrode displays high adsorption capacity of ∼21 mg·g−1, moderate energy consumption of 13 Wh·mol−1(Li+) with a remarkable increase in Mg/Li ratio from 1.67 to 158 in the original brine from Jiezechaka. Therefore, these results demonstrate a promising potential of C-LMO-Cr electrodes for long-acting electrochemical lithium-recovery from original brines.