Abstract
PBGAs with SnPb and SnAgCu (SAC) solder joints were stressed with temperature cycles on board- and system-level. A significant influence of the different solder materials on the location of the most damaged PBGA solder balls was observed in the experiment. The reason for this experimental finding was investigated and explained by FE–simulation. The simulations of the PBGAs were done on package-, board- and system-level (PCB within a metal housing). For the system level simulation a 2-step sub-model technique described in [1] was used. Through such an approach the transient PCB deformation and the transient temperature field within the ECU-housing can be incorporated into a creep simulation of the PBGA solder joints. The creep results for both SnPb and SnAgCu solder joints from the board- and system-level simulation were compared. The calculated damage factor due to the ECU-housing influence is different for PBGA with SnPb and SAC solder joints. The simulation results were validated step by step with measurements and experiments: warpage of the non-soldered PBGA, mechanical strain and temperature on the mounted PCB, crack length evaluation of all PBGA solder joints.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
