Abstract
Local measurements of axial liquid velocity were performed for vertical upward air-water bubbly flow in a 101.6-mm inner-diameter round pipe by using a laser Doppler anemometer (LDA) and a hot-film anemometer (HFA). The data reduction approaches for both the LDA and HFA are discussed in detail. A threshold scheme with the information of local void fraction and velocity distribution in single-phase flow was applied to the LDA to approximately discriminate liquid velocity signals from those of the bubble interface velocity. Furthermore, a formulation was given to account for the effect of the bubble relative velocity on the liquid in the front and wake regions of the bubbles. For the HFA, an amplitude threshold scheme and a slope criterion were used to extract liquid velocity information. To reduce the measurement uncertainty, the experiments were performed in flow conditions where the area-averaged void fraction was less than 20%. The experimental results showed satisfactory agreement between the liquid volumetric flow rates calculated by area integration of the local liquid velocity and void fraction measurements, and the measured value by a magnetic flow meter. Also, the area-averaged relative velocity between the gas and liquid phases obtained from the current measurements agreed well with previous research.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.