Abstract
Differential gear machine is often used for a car to smooth cornering. For the complexity that four bevel gears in a differential gear device engage at the same time, there are few papers that gathered up an analytic study about load distribution and tooth root stress distribution on bevel gears. In the case that three bevel gears in differential gear device engage at the same time, authors analyzed load distribution and tooth root stress in previous report. However, we did not consider the influence of side gear shafts and bearings in previous report. Therefore, in this study, by using FEM, deflection and stress of side gear which include influence of gear shafts and bearing were investigated and load distribution and tooth root stress distribution were derived. In addition, the crowning was examined and the influence of the crowning were clarified quantitatively.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
