Abstract
The tooth bearing in a bevel gear is sensitive to with assembly errors, shaft angle errors and deviation of apex, and the tooth end contact is easily induced. Therefore, it is important for strength design to know the load distribution on a line of contact and the tooth root stress of the bevel gear which is subjected to assembly errors and shaft angle error. In a previous report, the load distribution and the tooth root stress distribution with assembly errors in the direction of driven gear shaft and in the direction perpendicular to both of driving and driven gear shaft were calculated. In this paper, the load distribution and the tooth root stress distribution with assembly error in the direction of driving gear shaft and shaft angle error are calculated. Furthermore, the influence of assembly error and shaft angle error on bevel gear is clarified.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
