Lithium Plating Detection Methods in Lithium-Ion Batteries

Abstract

Lithium-ion batteries provide a low-cost, long cycle-life and high energy density solution to the expediting energy requirement of the automotive industry. There is a growing need of fast charging batteries for commercial application. However, large charging currents may cause Lithium plating which describes the deposition of metallic Lithium at the anode surface. It takes place at conditions of high currents and/or low temperatures because of kinetic limitations. The main reason behind plating is the slow solid-state diffusion of Lithium ions inside the active material. If the anode surface potential falls below 0 V versus Li/Li+, the formation of metallic Lithium is thermodynamically feasible. To avoid or reduce the amount Lithium plating, it is essential to detect its onset during a charging event.Determination of accurate Lithium plating curve is crucial in estimating the boundary conditions for battery operation without compromising life and safety. There are various data analysis methods involved in deriving the Lithium plating curve: anode potential using a three-electrode cell, variation of relaxation voltage after charging (dV/dt), variation of accumulated charge with voltage (dQ/dV) and coulombic efficiency of charge/discharge with %SOC (state of charge) are more commonly employed techniques. In addition to these methods, estimation of its occurrence is typically underpinned by electrochemical models where the negative (anode) electrode potential is expressed by a set of partial differential equations based on the electrochemical and physical properties of the battery components such as the electrodes and electrolyte. The present paper reviews the common test methods and analysis that are currently utilized in Lithium plating determination. Knowledge gaps are identified, and recommendations are made for the future development in the determination and verification of Lithium plating curve in terms of modelling and analysis.