Abstract
An analysis and controller design of double-input dc–dc converter (DIDDC) is introduced in this article. This converter is integrated with buck and boost converters at the front-end and a charge pump on the back-end. Salient features of this topology are as follows: (i) ripple content is low in source currents, (ii) both the dc sources are connected through an inductor, which gives rise to a smooth source current waveform, (iii) both the sources supply power to load either in standalone or simultaneously together, and (iv) two control–loops (one for source current regulation, while the second one for load voltage regulation) are sufficient enough to ensure power transfer/management from dc sources to load. To ensure power management on the input dc sources while keeping a stable closed-loop converter system, a multivariable diagonal controller is designed. The first diagonal controller performs the load voltage regulation task, while the second controller regulates input of source-2 dc current. From the control point of view, the double-input single-output converter becomes a two-input two-output control problem and exhibits control–loop interactions due to the power flow from two different sources to load through common elements. The impact of off-diagonal elements’ interactions is accounted by using decouplers. The <italic xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">H</i> <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">∞</sub> robust control theory and linear matrix inequality (LMI) principles are adopted to design reliable controllers. The structured controller of fixed order (PID) is designed by enforcing the necessary type LMIs. To demonstrate the feasibility and effectiveness of multivariable controllers of the DIDDC, a 60/24 V to 48 V, 150 W, 50 kHz topology prototype is constructed, and the power management aspects are investigated experimentally. Load voltage regulation, source current regulation, load sharing on the input dc sources, and power management aspects of LMI-based controllers were tested extensively for all possible disturbances. In all these test cases, the closed-loop double-input converter system is stable and robust in rejecting a variety of disturbances created.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have