Abstract
This work examines the nature of the strain distributions and limit stains during die quenching of a 7000-series aluminum alloy sheet. Forming limit experiments using limiting dome height (LDH) specimens were performed under plane-strain loading conditions using a 100 mm hemispherical Nakazima punch. Strains were measured using in situ stereoscopic digital image correlation (DIC). Two forming processing routes were examined: (i) an intermediate quench and form (IQF) processing route in which the LDH coupons were solutionized, quenched to a preset temperature, and isothermally formed and (ii) a die-quench (DQ) process where the LDH coupons were solutionized, and quenched and formed simultaneously with room temperature (RT) tooling under non-isothermal conditions. The DQ processing route was devised to understand the formability of the alloy under practical die-quenching conditions, while the IQF route was meant to understand the influence of temperature on the formability of the material. The DQ processing route exhibited the best formability from a localization standpoint; however, it was found that at deformations in excess of 0.5 major true strain, an orange-peel defect was present. The IQF process with room temperature tooling may be comparable to a W-temper forming operation. For these conditions, significant Portevin-Le-Chatelier (PLC) bands were present and the formability was approximately 75% less than for the DQ process. All formability results are summarized and a discussion of the interpretation of forming limits under the diffuse necking conditions associated with elevated temperature forming is presented.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have