Lightweight and High Impact Toughness PP/PET/POE Composite Foams Fabricated by In Situ Nanofibrillation and Microcellular Injection Molding.

Abstract

Polypropylene (PP) has become the most promising and candidate material for fabricating lightweight products. Microcellular injection molding (MIM) is a cost-effective technology for manufacturing porous plastic products. However, it is still challenging to fabricate high-performance PP microcellular components. Herein, we reported an efficient strategy to produce lightweight and high impact toughness foamed PP/polyethylene terephthalate (PET)/polyolefin-based elastomer (POE) components by combining in situ fibrillation (INF) and MIM technologies. First, the INF composite was prepared by integrating twin-screw compounding with melt spinning. SEM analysis showed PET nanofibrils with a diameter of 258 nm were achieved and distributed uniformly in the PP due to the POE's inducing elaboration effect. Rheological and DSC analysis demonstrated PET nanofibrils pronouncedly improved PP's viscoelasticity and crystal nucleation rate, respectively. Compared with PP foam, INF composite foam showed more stretched cells in the skin layer and refined spherical cells in the core layer. Due to the synergistic toughening effect of PET nanofibrils and POE elastic particles, the impact strength of INF composite foams was 295.3% higher than that of PP foam and 191.2% higher than that of melt-blended PP/PET foam. The results gathered in this study reveal potential applications for PP based INF composite foams in the manufacturing of lightweight automotive products with enhanced impact properties.