Light stability in cyan and magenta tones using standard and highly chromatic toner particles

Abstract

AbstractAn increasing requisite regarding the reproduction quality of electrophotographic printing machines demands improvement of new electrophotographic toner formulation, especially used pigments. The subject of this paper is a comparison of prints realised by depositing high chroma (HC) and standard emulsion aggregation (EA) toner on gloss fine art paper. HC toner has a different composition of the cyan and magenta tones compared with the corresponding standard EA toner tones and therefore behaves differently under real conditions. The patches used for this experiment were cyan and magenta tone prints with tone values (TVs) of 0, 20, 60 and 100%. Ultraviolet (UV) degradation was measured over time intervals of 0, 6, 12, 24, 48, 96, 144 and 240 h for all patches. Results (laboratory values) were calculated using colorimetric difference. Values were plotted as a function of time in tonal degradation graphs. A model was created using non‐linear regression‐based modelling. The experiment demonstrates that magenta patches are more susceptible to degradation in comparison with cyan patches. With the increase in tonal value, it is noticeable that the colorimetric difference is higher. Colorimetric differences calculated using HC magenta toner and standard EA cyan toner (100% TV) were higher than ∆E = 5, starting to appear after 6 h of exposure to UV radiance. After 12 h of exposure, colorimetric differences of standard magenta tones that were greater than ∆E = 5 also started to appear. Cyan patches (100% TV) printed with HC toner were more stable than the other patches, and after 240 h of exposure had not crossed the boundary of ∆E = 5.