Li experiments on T-11M and T-10 in support of a steady-state tokamak concept with Li closed loop circulation

Abstract

This paper presents a review of the last T-11M and T-10 tokamak activity in the field of Li plasma facing component (PFC) investigation. Attention is mainly paid to the realization of the concept of closed loop lithium circulation as a solution of the PFC problem of a steady-state DT volumetric neutron source on a tokamak basis. Realization of the Li PFC concept demands the decision of three main tasks: lithium injection into the plasma, Li collection before its deposition on the vacuum vessel and the return of Li to the injection zone from the collector. This emitter–collector concept assumes that the main heat flux from a hot plasma to the PFC (limiters and divertor plates) can be dissipated on the entire vessel wall surface by non-coronal Li radiation, which will smoothen the local heat load PFC. A rail limiter on the basis of a capillary porous system manufactured from tungsten felt and provided with W wings was successfully tested in the last T-11M experiments as a prototype of steady-state Li emitter–collector. A witness-sample analysis showed that the lateral sides of the rail and ring limiters crossing the plasma scrape-off layer can collect a significant (∼80%) part of Li, injected into the plasma during discharges. This can be used in the future for closing Li loop circulation. As was shown by Li pellet injection in T-10, the probability of Li penetration into the hot plasma core from its boundary is lower than that of deuterium by a factor of 5–10. This result can explain the effect of plasma cleaning (Zeff (0) ∼ 1) during T-10 Li experiments. Some different schemes of future lithium circulation loops are discussed.