Abstract
We fabricated piezoelectric MEMS energy harvesters (EHs) of lead-free (K,Na)NbO3 (KNN) thin films on microfabricated stainless steel cantilevers. The use of metal substrates makes it possible to fabricate thin cantilevers owing to a large fracture toughness compared with Si substrates. KNN films were directly deposited onto Pt-coated stainless steel cantilevers by rf-magnetron sputtering, thereby simplifying the fabrication process of the EHs. From XRD measurement, we confirmed that the KNN films on Pt-coated stainless steel cantilevers had a perovskite structure with a preferential (001) orientation. The transverse piezoelectric coefficient e31f and relative dielectric constant εr were measured to be -3.8 C/m2 and 409, respectively. From the evaluation of the power generation performance of a KNN thin-film EH (length: 7.5 mm, width: 5.0 mm, weight of tip mass: 25 mg), we obtained a large average output power of 1.6 µW under vibration at 393 Hz and 10 m/s2.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
