Layering and structural inheritance controls on fault zone structure in three dimensions: a case study from the northern Molasse Basin, Switzerland

Abstract

Listen

Translate article

Mechanical heterogeneity of a sedimentary sequence exerts a primary control on the geometry of fault zones and the proportion of offset accommodated by folding. The Wildensbuch Fault Zone in the Swiss Molasse Basin, with a maximum throw of 40 m, intersects a Mesozoic section containing a thick (120 m) clay-dominated unit (Opalinus Clay) over- and underlain by more competent limestone units. Interpretation of a 3D seismic reflection survey indicates that the fault zone formed by upward propagation of an east–west-trending basement structure, through the Mesozoic section, in response to NE–SW Miocene extension. This configuration formed an array of left-stepping normal fault segments above and below the Opalinus Clay. In cross-section a broad monoclinal fold is observed in the Opalinus Clay. Folding, however, is not ubiquitous and occurs in the Opalinus Clay where fault segments above and below are oblique to one another; where they are parallel the fault passes through the Opalinus Clay with little folding. These observations demonstrate that, even in strongly heterogeneous sequences, here a four-fold difference in both Young's modulus and cohesion between layers, the occurrence of folding may depend on the local relationship between fault geometry and applied stress field rather than rheological properties alone.